產品介紹：

循環時間業內最快，生產效率具有壓倒性優勢

最高轉速3200rpm（JM-438D）由于采用了電腦直接驅動方式，起動/停車反應迅速。與傳統機型相比機器時間縮短了約27%，使生產效率得到了進一步的提高。縫制物定位容易、正確枱壓腳裝置由脈沖馬達驅動，枱壓腳高度設定為2階段。縫制物定位容易，大大縮短了設定時間。此外，可適當輕輕操作踏板，踏板回踏時反應極佳。降壓腳噪音也得到大幅度降低，可輕松的進行作業。

切線后無需進行再處理

為使余線長度最短，采用了專用的移動刀和固定刀，并將固定刀配置在靠近布料的位置。切線后，線頭余線長度為2~5mm，無需再進行摘線工序。

Product Introduction：

Quickest circulation time in the industry,higher production effciency

Max Sewing speed 3200rpm(JM-438D) further enhanced production efficiency easy and exact orientation of sewing material, presser foot device controlled bu impulse motor, and height of presser foot set lor 2 stages to achieve easy sewing malerial orienlaslion and reduced set time, and press operating padel slightly, its response is very good and noise is much more reduced as well.

Unnecessary to redo
After being cut in orde to get shortest end of thread , special moving knife and fixed knife are applied , and put the fixed knile be aside sewing material.
After being cut, end of thread is of 2-2.5mm lenglh and unnecessary to redo it.